Switches and Sensors, Inc.
Strip-Switch™
Build-It-Yourself Components
Download a PDF of this page.
(Acrobat Reader required)
Use the following components for the field assembly and installation of Strip-Switch™ continuous switches: Cap Style Ends (all switches)
Cap Style Ends

Strip-Switch™ Continuous Switch
(supplied in rolls)
Available in types LR, MR, HR and LW. Minimum length is 25 ft.

Strip-Switch™ End Piece Sets
Each set comes with two end seals, active and passive:

Active: used for electrical connections to your equipment consisting of a lead wire and insert contact.
Passive: used for non-electrical end seal.

End piece attachment methods:

Heat gun: for all cap style ends
Adhesive: for molded style ends

Molded Style Ends (LW type only)
Molded Style Ends

Strip-Switch™ Mounting Channel
(For use when a permanent installation is required)

© Copyright 2003-2004, Switches and Sensors, Inc., All Rights Reserved